Beam and block garage floors

When a suspended garage floor makes sense, why vehicles change the design, and what the Building Regulations ask for where a garage joins the house.

Beam and block can be used for a garage floor, but a garage is not just another room. A car puts heavy loads on small areas of the floor, so the house floor figures in a span table do not apply. British Precast says beam and block floors may be used for garages where they are specified with a reinforced concrete topping, and that the topping should be designed by a competent person to current design codes. This guide explains when a suspended garage floor makes sense, what changes in the design, and what the Building Regulations ask for where the garage joins the house.

When does a garage need a suspended floor?

Most detached garages on good, level ground sit on a ground-bearing slab. A suspended beam and block floor is worth a look when the ground or the site makes a slab hard work, for example:

  • Sloping sites: where the garage floor would need a lot of fill to bring it up to level.
  • Poor or made ground: where a slab would need deep fill or the ground may settle.
  • Clay with trees nearby: where the foundations are deep and a suspended floor avoids the ground moving under the slab.
  • Integral garages: where the rest of the house has a suspended floor and it is simpler to build the whole ground floor the same way.

Our suspended ground floors guide explains when a suspended floor is usually advised, and the beam and block vs slab page compares the two.

What changes in the design

A house floor is normally designed for 1.5 kN/m² of imposed load, which allows for people and furniture. A garage floor has to carry vehicles, with their weight coming down through the wheels. That is why the figures in our span guide are for house floors only and must not be used for a garage. For a garage, the design looks at:

  • The topping: a reinforced concrete topping cast over the beams and blocks, designed for your floor. It spreads the wheel loads across the deck.
  • The beams and their spacing: often closer spacing or deeper beams than the same span would need in a house.
  • The blocks: some makers call for stronger infill blocks under a garage topping.
  • The deck preparation: makers’ own guides differ on garage floors, for example on whether the joints are grouted before the topping goes on. Follow the instructions that come with your floor, not a general method.

The beam layout and calculations for your floor show all of this. They are worked out for the job, so tell us at the start that the floor will take vehicles, and roughly what kind. A floor for a family car and a floor for a van or a camper are not the same design.

Planning a garage on beam and block? Send us your plans and tell us what will park on the floor. We’ll design the layout and calculations for vehicle loads and give you a fixed price. Get a quote for your floor.

Integral and attached garages: what Approved Document B says

Where a garage is attached to the house or built into it, Approved Document B (fire safety, Volume 1, paragraphs 5.6 and 5.7) asks for:

  • Fire separation: the garage separated from the rest of the house by fire resisting construction, at least REI 30. Diagram 5.1 shows this applies to the wall and any floor between the garage and the house, from the garage side.
  • The door into the house: where there is one, either the garage floor falls away from the door to the outside, so spilt fuel runs away from the house, or the door opening is at least 100mm above the garage floor.

Both affect your floor levels. If the garage floor has to sit lower than the house floor, or fall towards the garage door, that needs to be settled on the drawings before the walls go up. Building Control will check these points for your job, so ask them early if you are unsure.

Rooms over a garage

Beam and block is also used for the floor of a room built over a garage. That floor is part of the fire separation above, so it needs to give at least REI 30 from the garage side. Our upper floors guide covers rooms over garages, lifting the beams into place and what we need to price an upper floor.

Insulation and later conversions

Whether an unheated garage floor needs insulation is a question for your designer and Building Control. Think ahead if the garage might become a room one day. Approved Document L treats an unheated garage that becomes part of the heated home as a change to energy status, and the floor then has to meet the standards for that. Room for insulation and a screed is easier to leave now than to find later, as our floor insulation guide explains.

On site

  • Lay it as drawn: beams, blocks and any doubled beams go exactly where the layout shows. Beams must never be cut or notched on site.
  • No vehicles on the bare deck: keep cars, vans and plant off the floor until the topping has been laid and has gained the strength the design asks for.
  • Keep the void vented: a suspended garage floor still has a void below it, and the vents must stay clear.

Our installation guide covers placing the beams, laying the blocks and safe storage on site.

What we need to price a garage floor

Your plans, or a sketch with the inside sizes of the garage, are enough to start, along with the site postcode. It also helps to know:

  • what will park on the floor: cars, vans, a camper or anything heavier
  • whether the garage is detached, attached or integral, and if there is a room above
  • which walls will carry the floor, and the floor levels you need
  • whether the garage might be converted later
  • access for the delivery lorry

The floor layout and calculations are included with floors we supply, worked out for vehicle loads where they apply. We can’t promise what Building Control will decide, but you will have the paperwork they normally ask for.

What happens after you send your plans

A garage floor is priced the same way as any other floor we supply. The quote form asks for your name, phone number, email, and the site address and postcode. Plans help us price the floor accurately, and you can upload them as PDF, image, DWG or ZIP files, but they are not essential.

  1. You send your plans. Architect’s drawings or a sketch with the inside sizes of each room. Anything that shows the walls and spans.
  2. We set out the floor. Our engineers work out the beam depth, the spacing and any doubled beams for the vehicles you have told us about, and produce the layout drawing and the structural calculations your Building Control officer will ask for.
  3. You get a fixed price. A clear quote for the design, beams, blocks and delivery.
  4. Delivered to site. Beams are made to length and delivered with the blocks, with crane offload where needed, ready for your builder to lay.

Send us your plans for a free quote or call 02475 095700.

Frequently asked questions

Can you use beam and block for a garage floor?

Yes. British Precast says beam and block floors may be used for garages where they are specified with a reinforced concrete topping, designed by a competent person to current design codes. The floor is designed for vehicle loads, not house floor loads.

Can I use a beam and block span table for a garage?

No. Span tables are for house floors, normally designed for 1.5 kN/m². A garage floor carries vehicles, so the beams, spacing and topping are designed for your floor. Tell us what will park on it.

Does an integral garage floor have to be lower than the house?

Approved Document B asks that where a door leads from the garage into the house, either the garage floor falls away from the door to the outside, or the door opening is at least 100mm above the garage floor.

What fire rating does the floor over a garage need?

Approved Document B asks for the wall and any floor between an attached or integral garage and the house to have at least REI 30 fire resistance from the garage side.

When can I drive on a beam and block garage floor?

Not on the bare deck. Keep vehicles and plant off the floor until the topping has been laid and has gained the strength the design asks for.

Does a garage floor need insulation?

Ask your designer and Building Control for your job. If the garage could become a heated room later, Approved Document L treats that as a change to energy status, so leaving room for insulation now can save work later.

Ready to get your floor priced?

Get a free quote →
Call us Get a quote